Crushing Equipment

The TGM trapezoidal mill adopts a compact vertical structure, occupying a smaller overall space than ball mill systems of the same production capacity, and the height requirement of the plant is moderate. The weight of each model of the whole machine inc

The LM Vertical Coal Grinding Mill has a hot-air system using a furnace or kiln waste heat to dry coal (feed moisture up to 10%–15%). It is explosion-proof by design: seal-air on rollers and separator, temperature and CO monitoring, controlled oxygen,

High main-bearing temperature often comes from poor lubrication, dirty oil, low cooling water or overload. Check oil level/quality and cooling flow, clean filters, and reduce load if needed. Persistent high temperature requires shutdown to inspect shell

The MTW European Type Trapezium Mill adopts bevel-gear integral drive: the main motor drives the central shaft via a reducer for a short chain and precise ratio with smooth, efficient power. The integral bevel gear cuts loss and failure points versus bel

Metal pieces break through material bed instantly and trigger violent vibration, local chipping of roller sleeves and table liners, even damage reducer gear pairs. Manual inspection cannot fully block metal impurities. Install iron remover plus metal‑d

S5X circular vibrating screen can be equipped with 1‑4 screen decks; deck quantity determines number of finished fractions. Single deck is for simple pre‑screening to remove large impurities. Two decks produce three material fractions. Three decks ou